At the end of the day, all you have is yourself and all you need is your friends (and in our case our Patrol)
2006 GUI1 4.2TDi Coil Cab "almost" standard
threedogs (8th September 2014)
ron 004.JPGi have the arb delux bar and the bonnet protector sits higher than the bar don't see how my inter cooler is effected
I got stopped by the police last month and told to remove the fishing rod holders I had on my bullbar or next time he would defect my vehicle and fine me $300. I went to the RMS and asked for their opinion and they told me the same thing. The fishing rod holders aren't allowed to be past the edge of the bullbar or it's illegal.
The law may be different in Qld. I have seen quite a few others around here with the same setup I had.
Its not that they wernt designed for a bullbar, the scoop is poorly designed. The majority of the opening is taken up by slow moving turbulant air called a boundry layer, only a very small amount of faster flowing air can actually enter the scoop, all that because it is too low.
96 GQ coil/Cab
08 G6eT
MEGOMONSTER (9th September 2014)
They are also having to follow ADR requirements.
Is there link to take a look at the ARE scoops?
http://www.are.com.au/Inter/topMountIntercoolers.htm
Just scroll down to the scoop section.
2011 GU8 ST 3.0 CRD, ARB Bullbar with IPF spotties, scrub bars and side steps, Snorkel, Dual Battery system, Waeco fridge, Turbo Timer, ARB Roof Rack with 5 IPF spotties across the front, Custom full Leather Bucket seats, DPchip, 3" Taipan exhaust, ARE Intercooler & scoop, Autron EGT/Boost and dual volt gauges, ARB front locker.