QLD Members Working Bee - Expression of Interest

[hekarewe]

Hmmmmmmmm I seem to be missing a few tools and stuff.

my hands up!!!!!! have them in my boot my bad sorry about that can you PM your phone number so i can organise to get them back to as soon as possible so sorry pal

[Bigrig]

my hands up!!!!!! have them in my boot my bad sorry about that can you PM your phone number so i can organise to get them back to as soon as possible so sorry pal

Yeah, sure ... 'honest' mistake!!!! lmao

[Peacemaker]

You end up getting that 8g fuse holder?

[hekarewe]

You end up getting that 8g fuse holder?

have not had a chance yet was a bit second hand this morning after last nights supprise BBQ for the wife drank a bit to much but should be right soon i hope LMAO

[Yendor]

have not had a chance yet was a bit second hand this morning after last nights supprise BBQ for the wife drank a bit to much but should be right soon i hope LMAO

There is an inline fuse holder, that came with your driving lights that we did not use.

[hekarewe]

There is an inline fuse holder, that came with your driving lights that we did not use.

normally i would have picked up on that but the mind is a little fuzzy this morning oops today already pm lol

[Warnie]

Thye chinese safety boots are fine........b ut those legs damn theyre white fer a queenslander hahhahahahhahahahaha gotta be a glare issue there

I'm a Queenslander by location only though, I was born and bred in Victoria, so white makes sense lol

[Bigrig]

I'm a Queenslander by location only though, I was born and bred in Victoria, so white makes sense lol

Explains a lot for us as well ... 'things' make sense now!!!! lmao

[Yendor]

normally i would have picked up on that but the mind is a little fuzzy this morning oops today already pm lol

I'm guessing that Jason used 8 gauge wire, so the difference in thickness of the cable and inline fuse holder will be large.

But the inline fuse holder should be rated to at least 30amps, so it will quite happily run your work light/reverse light.

[hekarewe]

I'm guessing that Jason used 8 gauge wire, so the difference in thickness of the cable and inline fuse holder will be large.

But the inline fuse holder should be rated to at least 30amps, so it will quite happily run your work light/reverse light.

from memory he did will crawl out later and have a look and refresh my self lol