All Things Chev

[PeeBee]

OK, have the dual vee pulley installed, bracket in place, belt sorted out and DCV mounted ready for the hose guy. Couple of picks. The DCV is mounted behind the winch, which gives good access for installation, direct to winch and at the right height for the reservoir. Hope this helps PhilDSC01710.JPGDSC01721.JPGDSC01727.JPG

Bit of an update. The 2" pulley did not have enough surface area and would slip when the pump was idling, probably a combination of diameter and material(aluminium.) I have since changed this to a cast iron pulley of 3" PCD and much better outcome. The speed is slower, however I made a simple throttle lever to increase speed to circa 750rpm and the line speed is in the range of 4.5 - 6m/minute which is fast enough for what I use it for, and it will do this all day without effort if required.