HAHAHHAHAHAHAHAHA ya can settle it with a LOW CARB beer hahahahahaha damn angle grinders can be very unforgiving!
HAHAHHAHAHAHAHAHA ya can settle it with a LOW CARB beer hahahahahaha damn angle grinders can be very unforgiving!
IF YA DONT GET STUCK YA AINT TRYIN HARD ENOUGH........OR YA TOOK THE CHICKEN TRACK
WARNING: TOWBALLS USED WITH SNATCHSTRAPS DO KILL!!
Hahaha .. yeah, it was 'spot on'!! We didn't have to bend sh!t out of it so I could weld it in place at all .. did we?? LOLOriginally Posted by Dhuck
Apparently the cut was meant to be 400mm long and being the b@stard I am (according to dhuck), I put one of the marks at 405mm just to make him look bad!!! lmao
BUT!! I'll say again - couldn't have done it without ya mate - definitely needed both sets of hands!!
piccies, did ya get piccies as proof ???????? That will settle it!!! hahahaha
Well, done what I can today until the chop chop tomorrow ... Couple of coats of paint baked with the little hand held heat gun, drilled out those two bolts and cleaned up the threads (and whacked some anti-seize in them), cleaned up the bolts that are going back on, and measured up the bar work for the support arms (to be cut and welded in place on Tuesday ... it's getting there ... should be on Wednesday and the wide centre section of the shelf/drawer system goes in Thursday (side sections 4 weeks away!! Bugger!!) ... Tank is getting a bunch of lovin at the moment!!!
Kills me thinking of what's 'still' to be done - new rims, new tyres, engine rebuild with super charger, front bar customizing and powder coat, rock sliders, rear window frames and rubbers ... hope it holds it's resale value!!!! LMFAO!!!
All fun and games, but loving it ... going to have to export this thread somehow and turn it into a 'coffee table' magazine!! lol
Haha!! Nope - not quite that cruel ... that said, it was a 4" angle grinder - that's a pretty big power tool in dhucks little hands!! LOL!!!
should have purchased a Dremmel specially for Dhuck mate!!!!!!!!! hahahahaha
Haha ... Nah, he did better than alright with my dodgy gear!!!
Not that I actually did much but be a 2nd pair of hands and cut a bit of pipe before we buggered both cutting wheels on the pipe cutter. Don't let us borrow your tools. We use, we break but we do give them back. lol
In the words of a Dhuck "QUACK".
May be slow but.....................gees ya ruff hahahahahahahahahah
IF YA DONT GET STUCK YA AINT TRYIN HARD ENOUGH........OR YA TOOK THE CHICKEN TRACK
WARNING: TOWBALLS USED WITH SNATCHSTRAPS DO KILL!!
Would have been easier with a cut off saw. But I guess you have to work with what ya got. Although the pipe cutter was cutting beautiful till the wheel broke.
DhuckRig Industries. You Mod Them, We Bodge Them.
In the words of a Dhuck "QUACK".
Posting Permissions
Reply With Quote