EGTS Up Why?

[Bidja]

I'll stick my head in and take a look. I know we removed that solenoid from the equation, vacuum wise, but I don't know about electrically.

Is it possible to tune the standard setup? Standard ECU etc?

Last night I was adjusting the needle valve. At some settings I could hear something that sounded like something opening, like when a vacuum seal is broken, you hear that release of a suction seal. I assumed it was the actuator opening and closing, but I'm not 100% sure????

CRD requires the vacsol electrically connected (plugged into harness). or if vacsol is removed a resistor (330ohm 1/2 watt) is to be placed across the sol electric harness connector terminals. The ECM requires this load or limp type fault will occur.

A tune will be a remap of ECM (postal or a live on dyno).

Last night I was adjusting the needle valve. At some settings I could hear something that sounded like something opening, like when a vacuum seal is broken, you hear that release of a suction seal. I assumed it was the actuator opening and closing, but I'm not 100% sure????

Was the noise a drone sound and did u notice that actuator rod had dropped down at the same time?

Make sure that the needle valve fresh air bleed and vac hoses are of good condition and fit securely (3mm ID hose).

Much oil residue again in Dawes boost controller?