Quote Originally Posted by Buster3696 View Post
Hi Mudrunner,

Basically going to put my centre into the ute 3rd member to correct the spline issue and drop the lot into my coil housing.

Not sure what you mean about cheaper and easier to install the correct Crown wheel and pinion, the ute diff is $150

New gear sets are over a grand last time I looked...
Yeah cool, so you are going to dismantle the Crown Wheel and Pinion out of the 3rd member and refit it to the other one. Will you have to reset your back lash. I have read it is wise to measure the existing back lash before stripping it and reset it to that backlash or you can end up causing wear as the CR has to rebedded. I fitted one into my GU that was just reset and it whined like a biatch and i had to pull it out again. (Apparently it was a "Good" diff) It had been fully dismantled and just put back together for me to bolt in. I assumed the mechanic reset the backlash to Factory spec but i only did 100kms with it before pulling it out again damn it. Pulling Diffs out in the driveway sux! and dumping near $100 of diff oil and starting again got old.

After i blew my factory diff, swapped out for the Whining diff then remove and refit for the 3rd time i was cooked. The 3rd diff lasted 2 years before it blew damn it. After slugging it out on the driveway a few time i had the diff Fully rebuilt with brand new CR and Pinion and bedded it and ran it in properly and was the best $1600 i spent i reckon.