Harrop 2300 supercharger to Optimiser 6500

[PeeBee]

Are the 8 bent push rods all of one cycle? Like all the exhaust or all of the inlet or just one of the banks complete 8 push rods is bent?

Matt, the two worst are on the exhaust valves of 4 and 5, followed by minor bends mostly on the drivers side bank. i cant be too specific due to not taking enough attention as the bits were extracted. There was only the exhaust valve pushrod on the pass side cylinder which is either 4 or 5, the rest appeared ok to the eye/roll across the table top.bent 2.JPGbent 1.JPGrocker.JPG