OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

User Tag List

Results 1 to 10 of 10

Thread: Fuel problem - bleeding bulb empty - Primer

Threaded View

  1. #9
    Beginner
    Join Date
    Jul 2016
    Location
    Perth WA
    Posts
    21
    Thanks
    7
    Thanked 5 Times in 5 Posts
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Further update:
    Had the pressure relief valve replaced and all seemed good. That is, until on a road trip to Busselton (about 200 km) - the Dynamic Vehicle Control (DVC) light on the dash illuminated (constant on) with power loss. Pulled over, checked everything I could think of, but vehicle would not start. Reprimed pump several times and eventually started. Limped to Busselton.
    Next morning, difficulty starting with engine dying within 50 metres of driving. Re-prime, eventual restart, travel another 50 metres... all repeated x 3. Made it to workshop and noticed fuel leaking from top of fuel filter. Replaced fuel filter. All apparently fixed... (at least no fuel leak).
    Drive home and DVC light comes back on. Scan error codes with ScanGauge - gives pending code P0089. Clear code, DVC light clears, drive 200 metres, DVC light re-illuminates, pending code P0089 returns. Now getting tiresome.
    Back to the mechanic tomorrow for a full rescan of system. Will update if this ever gets fixed.
    As always, any comments suggestions are most welcome.
    2014 ST 3.0L CRD Manual | ARB bull bar and dual wheel rear carrier |ARB compressor and front Airlocker | 50mm lift kit and shocks |Safari snorkel |long range tank | dual batteries with Redarc management | rear camera | full length roof rack and awning, Hema HN7, Inverter, solar panels.

  2. The Following User Says Thank You to PRIGBY For This Useful Post:

    MudRunnerTD (15th June 2021)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •