Hi here are the drawes I made did not think to take any shots till after I started work fine
Hi here are the drawes I made did not think to take any shots till after I started work fine
AB (5th May 2011), growler2058 (6th May 2011), hutchy84 (9th January 2012), ozzyboy (30th December 2011)
Very neat and tidy job mate!!Originally Posted by stevsr31
Hi here are the drawes I made did not think to take any shots till after I started work fine
Very impressive mate!
Ten times better then my timber ones...LMAO
x2 very nice
Time is never wasted when your wasted all the time
WARNING: Towballs used for recoveries can, and do kill people and damage property.
them there are some pretty saucy looking drawers mate
Very good job mate well done
IF YA DONT GET STUCK YA AINT TRYIN HARD ENOUGH........OR YA TOOK THE CHICKEN TRACK
WARNING: TOWBALLS USED WITH SNATCHSTRAPS DO KILL!!
not three bad at all ............where`s mine?????
HELL NO !!!!!!
Nice work Steve. I wish I could work metal like you obviously can. If I had made mine out of metal, even with a MIG they would look like swiss cheese.
My timber ones are not that neat now, though I was pretty proud of them when I first made them. I used the sliding shelves from a computer rack, which have pretty good ball bearing runners.
The most expensive part was the marine ply and they are a bit heavy, but cheaper than ARB etc. Pity I made them a bit higher than I would like but they hold lots of s**t.
GU Series 4 Ti, 3.0 CRD Auto with extra bits
growler2058 (6th May 2011)
how did you make the fridge slider part
very nice good job
Posting Permissions
Reply With Quote