mudski (18th November 2018)
Silicone/Silastic would better seal pitting I would imagine?
Sent from my iPhone using Tapatalk
Can see the point, however the gasket is a surface seal, clamped with uniform pressure - or it should be if the thing is torqued correctly, so in theory, the pitting would be covered unless it goes to the edges of the hole and you have a channel from inside to outside, then a liquid seal would be better. Solid gaskets are not designed to deform as such, more cater for surface roughness values at best - I know sounds contradictory, but they will deform on a smallish level, not fill up depressions.
MB (19th November 2018)
Replaced the filter in my ProVent catch can. Old one looked OK for 80,000klms, the recommended replacement frequency.
2014 Titanium Y61 with all the fruit ................
Had a spazmotic idle when cold, ranging up to 770rpm.
Disconnected the start battery and sprayed tho MAF.
All seems to be OK now, happy with the outcome
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
GQtdauto (19th November 2018)
It broke down for the first time on the weekend since its conversion.
10,000 kay in on some hardcore trips including , snow, west tassie, high country and some hard core day trips...
I dont know what it is but will get to it eventually
https://youtu.be/NA1yj32XRvc
GQtdauto (21st November 2018)
I saw that vehicle drag a land rover out of the Caledonia River via Dingo Hill, did it like a walk in the park, amazing machines