Quote Originally Posted by lsmitti View Post
Well, Broke an easy out in the bolt I was trying to remove from the cylinder head. Pretty much at my tether with this thing.

Idea's on removing a broken easy out?

Diamond Tip hole saw, carbide drill tip, Dremel?

Might be about time to take it to the shop.

Not the best way to end the weekend
This is what I used when the same thing happened to me.
Luckily for me, I had the cylinder head on the bench, which made it tad easier to access it.

https://www.ebay.com.au/itm/6mm-Dia-...4383.l4275.c10

You can buy those diamond tipped hole saw bits from a Tool shop. Just get the size you need to cut through the stud.
If you're careful enough, you can pretty much end up not having to tap the hole to the next size, but use the same size tap
to clean the slightly damaged thread.

I have a kit of the above diamond tip hole saw bits in case it happens again.