got the uhf... from perth arrived lunch time,
got the uhf... from perth arrived lunch time,
if its worth doin its worth over doin
uhf is fitted.
the wife just complained the front doors make too much noise and a too hard to move. anyone say new door hinges :P
if its worth doin its worth over doin
swapped the old 100 w hella's for a aurora style 20" light bar.
trying out a thing similar to g70. but a ceramic not ptfe.
if its worth doin its worth over doin
nice work!
yep thrust bearing IMG_20170719_180628.jpg
IMG_20170719_180535.jpg yep a nissan clutch in my ford. over 500 000km on that one.
IMG_20170719_181442.jpg box and transfer out.
IMG_20170719_180416.jpg new bits ready for the box.
if its worth doin its worth over doin
been a little while since i've done much on the mav, knocked up a box for the sub and a couple speakers with an amp to go under the back seat. just need a couple bits and i can fit it in.
if its worth doin its worth over doin
AB (17th November 2017)
got the box wired up well nearly. but i do have doof doof. will be running 6 speakers and a sub. might even drown out that annoying noise in the back seat...
if its worth doin its worth over doin
NissanGQ4.2 (24th November 2017)
So instead of rocking the kid 2 sleep your going 2 doof doof it 2 sleepOriginally Posted by garett
Time is never wasted when your wasted all the time
WARNING: Towballs used for recoveries can, and do kill people and damage property.
found the bash plate under the fuel tank was loose. that bolt came out got cleaned up and locktited then tightened till it held everything from moving. this required one foot on the rear bar using a short breaker bar....
if its worth doin its worth over doin
Majestic (22nd January 2018), rusty_nail (22nd January 2018)
got around to replacing the bailey channel. in the drivers door. just need to trim the door card to fit speaker surround. and i should be done pulling it apart till i do hinges
if its worth doin its worth over doin
Rossco (10th February 2018)
Posting Permissions
Reply With Quote