Sub tank rollover valves rmoval

[rusty00]

I cut and extended my sender float shaft using coat hanger wire and solder. So the float drops to the same level as it would in the oem tank. Probably not the best way about it but i did with what i had at the time. Its been in there for some 18months and no issue so far.

Sent from my SM-P600 using Tapatalk

r

I used the wire supplied and used the mig to put 4 x tacs on each end, 2 each side basically a full weld over 10mm.
Should last a life time. Either way its just a sub tank.