AB's new GQ is finally here

[nissannewby]

Forward entry for a front mount. Its all about the volume mostly. You can see how the entry pipe is against the back wall. It also has 300+mm from entry point with no restrictions (so no directional changes or wall). You need a minimum of 50mm all the way across. dont worry about tapering ends off etc just get the height for the volume. Centre entry should also follow the back wall.

[nissannewby]

BTW, looks very sexy!!!

Who how and $$$ if possible lol

Yep. It has 100mm of lift at the lowest point. Cost was about $450. I just used a fabricator we use through work up here. He doesnt do car stuff but I get special treatment lol.

[Winnie]

Hey Mat what's the thread for on cylinder 4?

[AB]

Hey Mat what's the thread for on cylinder 4?

Probably just boost gauge, recirculation and pump?

[nissannewby]

Hey Mat what's the thread for on cylinder 4?

For a clamp that holds the injector likes on later engines.

[AB]

For a clamp that holds the injector likes on later engines.

Where do you tap in for my comment above?

[nissannewby]

Where do you tap in for my comment above?

I will grab a pic soon and post it.

[nissannewby]

Reference lines go here for boost controller, compensator and boost gauge. With a spare.

[AB]

Reference lines go here for boost controller, compensator and boost gauge. With a spare.

Yeah right..that is way too neat!!!

[nissannewby]

This is the bolt that winnie asked about. Its the bolt that looks closest to the head.
.