Belt Tensioner Assembly (CRD)

[Sir Roofy]

I've bought that one..
Bearing is an nks bearing which imo should be good..
But the bushes are shoit.
I'm serious looking at making some..
Maybe even a tensioner change over setup.. you give me your shagged one and I'll give you a rebuilt one with quality parts..

Sounds like a plan what about this bearing ntn wc-87503 ive used it a few times in a rebuild
if the body is ok bolt holes not worn little shocker ok for $30 for the bearing go for it
at the moment I'm running a $50 jobbie of e bay seems ok so far time will tell
you can also get the pully from auto barn $70 not sure about the price but you can get them
plus a torx tool

[BigRAWesty]

Sounds like a plan what about this bearing ntn wc-87503 ive used it a few times in a rebuild
if the body is ok bolt holes not worn little shocker ok for $30 for the bearing go for it
at the moment I'm running a $50 jobbie of e bay seems ok so far time will tell
you can also get the pully from auto barn $70 not sure about the price but you can get them
plus a torx tool

Yep I can get that bearing.. and was going to rebuild my factory one..

[TPC]

Does anybody know what torque the pivot bolt should be tightened to?

[Sir Roofy]

Does anybody know what torque the pivot bolt should be tightened to?

I just do it up till tight but if your fussy its 68-77 nm
tensioner retaining bolt 25-28

[BigRAWesty]

The above linked part number is $155.54 from dubai. I wonder how much shipping would be.

Is that genuine from Dubai?

[threedogs]

http://www.ebay.com.au/itm/111995440...%3AMEBIDX%3AIT
This was the replacement bearing I was told of.

[Cuppa]

http://www.ebay.com.au/itm/111995440...%3AMEBIDX%3AIT
This was the replacement bearing I was told of.

Description says single row ball bearing & pic shows double row roller bearing?????

[Softy]

I just do it up till tight but if your fussy its 68-77 nm
tensioner retaining bolt 25-28

Same here i do it by feel... Apparently if over tightened it can stop it from pivoting but i have never had an issue.

[Sir Roofy]

Same here i do it by feel... Apparently if over tightened it can stop it from pivoting but i have never had an issue.

No issue here either easy job but one you don't need on a trip

[Sir Roofy]

Description says single row ball bearing & pic shows double row roller bearing?????

Took his glasses of and miss printed it