Hodge's new 4.2

[Hodge]

I've called it i won't be doing it. I got no means , time or premises to do it so to workshop it goes.

Sent from my SM-G920I using Tapatalk

[Winnie]

I chickened out of cutting mine too, only cost a slab of crownies to the panelbeater. He said don't use a grinder, and used an air hacksaw.

[BigRAWesty]

I chickened out of cutting mine too, only cost a slab of crownies to the panelbeater. He said don't use a grinder, and used an air hacksaw.

Less sparks, less finish work.
Either a hacksaw or piston nibblers (drill powered ones) work well and leave a nice clean edge..
Just make sure you use em on a clean flat surface.. the shavings are half moon shaped spikes from hell!!!!

[gubigfish]

I took mine to a panel beaters and they cut the hole, welded a piece into the bonnet, painted the bonnet and scoop and fixed some holes and resprayed my left hand guard for $900 cash

[Rocket55]

I used an air hacksaw for mine, worked a treat .... Twice.

[Hodge]

@mudski @Rocket55

How are your fans for the inter cooler wired up? There is not a single bit of info or instructions on how it's meant to be setup.

There is a blue wire in the loom I believe, so is it intended to be constant on with IGN ?
For some reason I believed/though the fan was thermally kicked in. My bad.

[nissannewby]

Dont fit it....

[mudski]

There's ignition power in the wiper motor. Thats the easiest spot to get power.
The blue wire would go here.
Sent from my SM-P600 using Tapatalk

[Hodge]

There's ignition power in the wiper motor. Thats the easiest spot to get power.
The blue wire would go here.
Sent from my SM-P600 using Tapatalk

Yeah that's where I already got ign from for my Redarc. So I'm guessing it is meant to be like that always on when ign on ?

[Hodge]

Dont fit it....

Not a fan of a fan Mat ?