Roofys Motor Discussion thread

[Rossco]

I can help with the remove and refit. I'm far from a mechanic though. So I am more than happy to step aside if need be and just hand over spanners etc etc. If the budget allows for new injectors I would get them. I'm not sure about the pump. But These pumps need to be bled properly because they have a circuit board built into the pump which is cooled by the fuel. And if you don't bleed these pumps you get an air lock in the pump, then you fry the circuit board and its bye bye pump, which is around $3.5 to $5K to replace. You cant replace the circuit board on these pumps.

Same here no awsome mechanic that's for sure but more than happy to spin some spanners and help out where i can. I reckon definatly new injectors if there's budget. What about testing turbo & pump. Where should we take them - dieseltec, jpc or somewhere else??