What has made you Happy today??

[BigRAWesty]

Why is it so tight??
Personally cut it off and put a new bit on it.

[Hodge]

Why is it so tight??
Personally cut it off and put a new bit on it.

I hate losing... So it's coming out!

The previous owner fished a lot, and kept dunking the car into the ocean when he was dropping the boat off. Hence why my car had that surface corrosion across the whole underbody, so this being the way it is doesn't surprise me one bit. I don't think it's ever been out since being fitted by the dealer.

[BigRAWesty]

Ummmmmmm.
Ditch the lot.
Paint only protects the outside.
Who knows what the inside is like.

[mudski]

Id just cut the tounge off and cold chisel the fecker out mate. Bring it back over tomoz and ill get it out that way.

Sent from my SM-P600 using Tapatalk

[Stropp]

mine was the same as it was a dept fisheries car, took some doing but it eventually came out and then i ground it a bit to loosen it up and check it all the time to make sure it doesnt happen again. Keep at it

[mudski]

mine was the same as it was a dept fisheries car, took some doing but it eventually came out and then i ground it a bit to loosen it up and check it all the time to make sure it doesnt happen again. Keep at it

Mate this one is stuck, real good. I had it soaking in Hydrochloric acid after it was soaked it phosphoric acid just to release the rust. Then heated it up to screaming hot, then hit it with some freeze release and had it under 12ton of pressure and it only move 5mm. If i though about it when i had it i should have cut the tounge off and chiseled the rest out.

Sent from my SM-P600 using Tapatalk

[Bloodyaussie]

This is the message irish sent me when i asked and he swears by it...

50% acetone, 50% auto transmission fluid mate, put em in a cheap spray bottle, mix together and spray liberally, leave overnight if you can and make sure you don't get it on any paintwork.

[mudski]

This is the message irish sent me when i asked and he swears by it...

50% acetone, 50% auto transmission fluid mate, put em in a cheap spray bottle, mix together and spray liberally, leave overnight if you can and make sure you don't get it on any paintwork.

Yeah I know of that mix. I didn't have any acetone on hand when I had the bar...It works well though, but its just that little bit too thick and wouldn't run down to where it needs to go. Even CRC was too thick. I had 12T of pressure on it and the bottom support plate of the Press was starting to bow. Lol

[threedogs]

Belt it back in then out again it should slowly free up.
agree with Kallen I would of cut and welded a new hitch receiver on it.
But know that feeling when you have an itch lol go you good thing.

Be very carefull if you hit it under load, Dont

[Hodge]

but its just that little bit too thick and wouldn't run down to where it needs to go. Even CRC was too thick

I've opened up the sides now plenty of room to shove liquid in there. Acetone and oil it is.


Sent from my SM-T705Y using Tapatalk