Didnt you get yours for free?Originally Posted by AB
Didnt you get yours for free?
96 GQ coil/Cab
08 G6eT
Lol. It would be still too dear for him....
Sent from my SM-P600 using Tapatalk
Yes I did, wasn't yours for free too?
It sure was.
96 GQ coil/Cab
08 G6eT
AB (16th August 2015)
You two should get a room.It sure was.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
@ Winnie if you are spray can painting it, can I suggest that you heat up each
part to open up the metal a bit, paint sticks better too, a floor radiator is enough
Used this method on motor cycle tank.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
It would have to be free. They're too tight to pay for things!
mudski (16th August 2015)
Why pay when they're free?
Well I've again ditched the sand blasting idea because I don't want to have to strip all the bearings and the sand will ruin them. I will use a wire wheel to clean it.
In saying that I might still sandblast the lower housing and fill the needle bearing with wax to keep the sand out, there are too many tight spots that are full of dirt and crap that would be a nightmare even with a die grinder.
So the wire wheel will scratch it up nicely for paint. Not sure if I will need to use etch primer or not? Darren?
Come up pretty good with the wire wheel! Just need to use the sand blaster to get the hard to get bits.
AB (20th August 2015), MudRunnerTD (20th August 2015), Rossco (20th August 2015)
Posting Permissions
Reply With Quote
