gq patrol into trailer

[Bryce]

hey guys new to the site and was just wondering if anyone on here has turned a gq chassis and body or tray in to a trailer and was wondering how much it costs for the work to be done and the engineering.

Thanks Bryce

[seehuusen]

It is probably only something that someone who can work with a welder and do it themselves would do... besides, the cost, which you're probably better off getting a quote off a metal fabrication shop from, the engineering would have to conform to DOT rules as a trailer bigger than 750KG. You can look those rules up for the state that you live in on their respective website.

[Clunk]

No idea on the cost, but They look good

[ashmccormick]

Why waste a good GQ body and chassis... Thats what Toyota's are for

[threedogs]

Leave the chassis and cut down leaving the fire wall, you would need to know how to strengthen and
extend the chassis rails, remove the tail shaft as well.
You'll need to have the brakes working because of the weight too.
If you do some measurments you may be able to weld another rear 1/4 cut onto the front.
I was toying doing this with a 75 troopy body,heaps of room.
I made a single cab hilux tub camper, using only the best at the time, there is not much change from $3K
Personally I think the balance will be all wrong.

[Bryce]

I was thinking if you got a cheap rolling chassis and have a ute tray with a canopy instead of the cab

[4bye4]

Why waste a good GQ body and chassis... Thats what Toyota's are for

I agree with Ash.

[Woof]

Hey mate, how about posting up an introduction as it is something we like all new members here to do before seeking assistance
Just go here http://www.nissanpatrol.com.au/forum...-Introductions

[threedogs]

I was thinking if you got a cheap rolling chassis and have a ute tray with a canopy instead of the cab

that doesn't make sense to me, you might as well buy a 7 x 5 tradie trailer

[dom14]

hey guys new to the site and was just wondering if anyone on here has turned a gq chassis and body or tray in to a trailer and was wondering how much it costs for the work to be done and the engineering.

Thanks Bryce

That would be pretty heavy trailer. Why not build a one from scratch with an axle, tow hitch, couple of springs and square steel bars?
Of course if you need a super strong one, then a vehicle chassis/diff housing one would be the way to go. But, you'll still be limited to the width of the vehicle chassis/diff housing though.