I was going to say use a bus bar or you can do what I'll be doing.
Use a fuse block in the passenger kick panel like this one
http://m.ebay.com.au/itm/301518048768?nav=SEARCH
You then simply run your power feed in and out into the same stud on the fuse block. The advantage of this is it gives you 6 fused circuits you can use as opposed to a busbar that will need individual fuses any way
The only disvantage to this is it doesn't allow for high current loads like a compressor or amplifier but doubt you'd be using these up front any way ( only because the Max fuse size is 40amp)
Reply With Quote