Craig's GU ute

[DX grunt]

Fantastic GUte.

Rossco

[(AUST)Mod]

Which engineer did you use for the seating capacity increase?

[clawrence]

For the seating capacity engineering I used
Endracon
6 Brighton Mews
Hillarys
Then took my car along with the paperwork and new compliance plate provided by Endracon to Dept of Transport in Osborne park for the inspection

[d.n.blewitt]

Nice post mate, I'm looking to change my bucket out for a bench to have the extra seat for a kid.

May got to the same joint I did for the engineering cert.

I'm not sure on what I need parts wise yet. Thinking the bench from a DX, middle seat belt lap sash and gearstick surround. Believe I need to change the hand break as wel but not sure on that yet. Anything else I'm missing?

[clawrence]

Hi

Yep, that list what I used. Dx Bench Seat, Dx Gear lever surround (including boot), Dx Handbrake boot & plastic surround to affix to floor, Dx Centre seatbelt (both male & female), Dx bolts for seat & seatbelt.

The torque settings for the seat & seatbelt bolts are in the workshop manual.

There are a couple of good threads on the forum on how others have done it.

Regards

[d.n.blewitt]

Cheers, started searching wreckers for parts so hoping I'll have all parts n be able to install by mid jan.

Thanks again mate

[Cuppa]

Good stuff Craig, have only just caught up with your thread. Seems you are making some neat & sensible mods. Will have to now google United Fuel injection’s Fuel Manager.

[pasbogdan]

Fathers Day came around and as I had been going on and on about an LED Lightbar my missus decided to shut me up with a 100W Narva...

My missus hates the fact i showed her what you got and i want too...