AB's new GQ is finally here

[AB]

I like your thinking Andy, rivets sounds a good idea but you definitely want the washers

I like the idea too

Bearing Wholesalers and another local bolt shop don't have them that small though.

Needs to be 3mm hole and minimum 8-10mm size washer.

Need to head into the big smoke = Bayswater

[Winnie]

If not I'm sure you could make some. You'll need to put heaps of rivets into it though, they need to be close together

[nissannewby]

You can get quite large heads on rivets if you require it. You might get lucky and get one with an 8mm head.

What about nutserts?

[Alitis007]

Why not make your own with a hole saw ??

[AB]

Why not make your own with a hole saw ??

If I can't find them then yep, was thinking that too.

[AB]

You can get quite large heads on rivets if you require it. You might get lucky and get one with an 8mm head.

What about nutserts?

If this doesn't happen then nutserts was my second choice.

They would have to be small though.

[AB]

If not I'm sure you could make some. You'll need to put heaps of rivets into it though, they need to be close together

We use stainless steel rivets at work. I have buckets of them

[growler2058]

I'm considering mounting the Bushranger flexi flares using stainless steel pop rivets and I'm trying to find some washers to suit just in case it pulls through the rubber.

The custom folds are tight (would still work using bolts but tight) and it would make cleaning mud easier as well. I do not want to drill screws or tek screws in there, I can't stand that!

Thoughts on this? Haven't seen many people doing it so I'm second guessing...lol

Being to a few local shops and no joy on washers that small either?

I used rivets and the screws that came with them

[AB]

I used rivets and the screws that came with them

No rivets in my box, just self tappers.

[growler2058]

No rivets in my box, just self tappers.

Rephrase
I used rivets AS WELL as the self tappers that came in the box