The Broken N Bent thread, with fixes if possible.

[sil3nt_dr3ams]

[megatexture]

I should do that to mine before I bend them lol

[Bloodyaussie]

Been meaning to ask someone about my ARB side step/side protection bars... the step part of them are bowed from using them as sliders and to pivot on and want to take them off and clean straighten and paint...

Now how would I go about getting them straightened ??????

[Winnie]

Been meaning to ask someone about my ARB side step/side protection bars... the step part of them are bowed from using them as sliders and to pivot on and want to take them off and clean straighten and paint...

Now how would I go about getting them straightened ??????

Hammer. Really big hammer.

[threedogs]

@ BA use an up right hydraulic press will need to blokes press past centre then relax.
Should be easy enough or make a jig using your hydraulic juack

@ SD Nice laminating work BTW

[sil3nt_dr3ams]

Been meaning to ask someone about my ARB side step/side protection bars... the step part of them are bowed from using them as sliders and to pivot on and want to take them off and clean straighten and paint...

Now how would I go about getting them straightened ??????

Upload some pics mate,

[sil3nt_dr3ams]

@ BA use an up right hydraulic press will need to blokes press past centre then relax.
Should be easy enough or make a jig using your hydraulic juack

Nice laminating work BTW

Lol cheers,

Depending on how its bent it can be shitload easier to notch the steal then weld it back up.

[Bloodyaussie]

You can see in this pic what I mean.... I will be removing them as I want to also fix the bullbar

[threedogs]

Could cut with fine disc then re weld when straight

[sil3nt_dr3ams]

Side steps I would heat up clamping them down to a nice metal H or I beam or something straight and a lot stronger than the pipe.