g'day gents, wondering if there is anyone out there that would want to swap all parts involved in changing my buckets (that are like new) to a bench seat arrangement. they will also get a RMW canvas seat cover to suit the bucket and i would also be willing to travel but not inter state so anyone who can help me out please give me a buzz as my family has grown and i need the extra seat cheers...G
2008 GU 2" LIFT, GME UHF BLACK KING WHEELS, SAFARI SNORKEL, LIGHTFORCE 240' KAYMAR DUAL WHEEL CARRIER STEINBAUER POWER, beaudesert 2 3/4 system, runva 11,000 comp winch.....
still need one gentsOriginally Posted by grimace
2008 GU 2" LIFT, GME UHF BLACK KING WHEELS, SAFARI SNORKEL, LIGHTFORCE 240' KAYMAR DUAL WHEEL CARRIER STEINBAUER POWER, beaudesert 2 3/4 system, runva 11,000 comp winch.....
PM sent, mine is a 2005 GU also.
Sorry mate only saw this thismorning
Last edited by macca; 31st December 2013 at 07:00 AM.
Cheers
Macca
made my day Macca, pay it forward
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
macca (31st December 2013)
Graham I will get the seat/s out of the shed and the seatbelts etc that go with it.
It did have a seat cover but I now remember giving it to a mate so I will have to check what state its in.
Will put up some photos on here for you to assess.
The network is working a treat TD, what do you reckon?
Cheers
Macca
Here you are Graham,
Seat, Belts and gear shift surround.
The seat and belts could do with a good clean as they have been on the storage shelf in the roof of my shed for 3 years.
Will try cleaning the belts for you but the seats will probably need to be done with a upholstery cleaning machine at a car wash, be a better looking job. Could always fit a seat cover.
Last edited by macca; 1st January 2014 at 08:10 PM.
Cheers
Macca
Are the bolts stuck in the back of the seatbelts?
Macca, could I trouble you for a closeup photo of how the two stalks fit together at the bolt end: ie spacers / washers?
Last edited by P4trol; 1st January 2014 at 03:06 PM.
Not sure if that's how it was as I pulled it apart to get it through the seat. The centre One are both marked "centre".
Cheers
Macca
A thousand thanks!
I'm doing the same as the op, putting in a 3/4 bench seat. I have the seat, but needed confirmation about the seatbelts, specifically what hardware was used with the bolts. Now I know the bolts, seatbelts and hardware I'm looking for.
Yes I don't think they are in original order, but the arrangement is fairly logical. .
P4trol, One of the pieces that bolt to the floor has a washer as part of it, the black one in the pic.
Graham I gernied the belts and they look a lot better.
Cheers
Macca
grimace (2nd January 2014)
Posting Permissions
Reply With Quote