our car

[MudRunnerTD]

The hole in the pic are they a rated point for recovery/double line pulls etc 90% sure its a tjm bar

I would not.

[healy]

I would not.

Thats what I was thinking cheers

[Stropp]

good work mate, good to see things are going your way and congrats with the bub too mate.

[Squalo]

Ill have to change that pic and hide it I must admit I lost a lot of enthusiasm about 4wding with that thing. The hole in the pic are they a rated point for recovery/double line pulls etc 90% sure its a tjm bar

Might be an ARB bar. Definitely not a place for a shackle, that loop is designed to be used with one of these, and a high-lift jack. I see sooo many people snatching using those... they must be tough because I don't know of a failure yet, but the point is that it is NOT designed for recovery loads.

You need to put proper recovery point/s on the chassis horns.

[taslucas]

I got my bar modified to strengthen it up for a winch and at the same time welded 5mm plate next to those eyelets to thicken them up. The plates go back to the chassis mounting points. Tough as now.

[happygu]

The new wheels has arrived

Looks pretty neat ... not too many look like that by now

Lets hope it is a good one for you - either way you can't really lose on this one for the price.

Mic

[trekster]

Looking good Healy, did you end up stripping the other car or sold it whole?

[BigRAWesty]

Well done mate. Looks clean as..
Now those holes in the front if the bar. They are an intended winch point. Those points run inline with the chassis points..
I would feel safe using them if winching a double line or bridle Off them, but not snatch.

Anyway mate. To celebrate it, I'd like to offer a swap.. And before you say no, to late, Its done..
Sell the gu light mount and Im doing you up a stainless gq one. I just need the bolt centers again for the bar..

Lets start this bus with some bling..

[healy]

Looking good Healy, did you end up stripping the other car or sold it whole?

Parting it out to pay for the parts needed for this like to get a rear bar and snorkel dosnt have a snorkel yet

[healy]

Well done mate. Looks clean as..
Now those holes in the front if the bar. They are an intended winch point. Those points run inline with the chassis points..
I would feel safe using them if winching a double line or bridle Off them, but not snatch.

Anyway mate. To celebrate it, I'd like to offer a swap.. And before you say no, to late, Its done..
Sell the gu light mount and Im doing you up a stainless gq one. I just need the bolt centers again for the bar..

Lets start this bus with some bling..

I was just gonna fit it up this one should be fine