I shuddered when I read on here a day or two ago of a GU which has an electronic accelerator. What would you do if your alternator died mid Simpson?
I shuddered when I read on here a day or two ago of a GU which has an electronic accelerator. What would you do if your alternator died mid Simpson?
2006 4.2TDi ex-Telstra Remote area Camper. Patrol Sold after 11 years of ownership Replaced with 2006 OKA NT Expedition Truck. Cummins, Allison & lots of goodies
A Nomadic Life (Blog)
What I don't like, is that when its time to replace my old clunker, the only machines available to me will be the stuff thats Hi Tech now, but all of the extra systems, sensors etc. will be old and ready to go pfffffft! Maybe cars in the future will be throw away, just like some of the cheap mowers .
My advice is: not to follow my advice.
I like old school but like the new efficient 4x4s as well,.Yeah drive by wire like a slot car controller,
What happens when it fails you,,,,,,,,,,,,,,,,, see pic no words needed
Old technology looking on, how embarassment.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
I understand new tech being better and more fuel efficient but you can beat the reliability of old tech even if it costs a bit more
Just tap it in just tappy tappy tappy
Read in an RACV mag years ago that the early Datsuns had a projected life of 22 years.
My advice is: not to follow my advice.
Hey Rusty, I see on the early post, that you said there is on power to the petrol pump. If you have the switch on petrol, and the ignition on run, then you should have 12volt from earth on the Green red wire at the top of the fuel tank for a few seconds, ( oil pressure timer working). If that isn't there, then check the fuel control module, (d/s kick panel) there should be 12 volts at the green red wire (for a few seconds) The brown wire has 12 volts for on and start, and the light green wire 12volts for on and accessories. Since you have gas fitted, try the wiring at thepetrol/gas changover switch. Failing all that then the oil pressure switch on the engine block (d/s under the inlet manifold, Green wire) may be the problem. (clutching at straws now)
Last edited by mudnut; 8th February 2013 at 07:24 PM.
My advice is: not to follow my advice.