Quote Originally Posted by Bigrig View Post
Couple more progress shots (not much progress though!! lol). Have just tacked the top bar on to get the angle for the bottom tube ... at the join on the corner, both tubes run down the car together with the outer edge of the smaller one sitting about 30mm inside the outer edge of the larger tube to sort of 'taper' it in line with the body and not look too boxy ...

Tomorrow is another day, so the welder has been put away for today!!

ImageUploadedByTapatalk1305876354.272215.jpg

ImageUploadedByTapatalk1305876371.189227.jpg

Holding the bottom tube just to give you the idea of where it runs from/to ... pretty stoked that my angle cut to the mounting plate (by hand with the angle grinder) was bloody spot on!!! Miracles will never cease!!! lmfao

ImageUploadedByTapatalk1305876387.566310.jpg


ImageUploadedByTapatalk1305876404.388405.jpg

comming together nice mate,gloss is a bit shiney tho lol