My 240 volt compressor was on the fritz today and needed to use my pneumatic nailer so thought I'd plug it into the new double thumper from that joint , so plugged in the air lead and gun plugged in thumper , it ran for about four seconds and cut out .
I'm swearing and cursing and checked volts but they were ok , maybe a fuse , no that was ok , now I'm thinking that cheap is not always good you idiot serves you right .
Mate who was with me picks up nailer and starts nailing away and after the third nail the thumper fires into life for two seconds and cuts out again , then I realised that it's turned off because that's what this one does when it gets to 150 psi
Now where's that bloody instruction manual I turfed .
For the record I tested the three inch nail gun as well and no problem .