The "Tank" - Big, Grey and Ugly ..

[Bigrig]

Hey Scotty, nice job on the bar wings mate. look a treat. Your GQ looks real shiny too mate, nice unit.

If i may, my only thoughts on you wings are that they look like they stick out a little too much too each side mate and kinda make the back end look really wide? Could be just me or the pic but because you went around your panels they are that much wider rather than snug up under the 1/4 chops. All good though mate. Looks a treat.

I will reply to your Trim thread for centre ideas mate.

Cheers MR

Thanks mate - it's just the angle of the shot - thought the same thing, so that's why I took another shot over the corner to show they're tucked into the sides and meet up neatly with the flares.

[Bigrig]

looking Good Scotty I want to do mine now but i think it may expose the lpg tank too much

I thought the same mate, but it doesn't change it's position as it were - it's going to get knocked about either way, and seeing as I'm going back to full petrol in the next month or so, the fuel tank tucks up a few inches more also.

[Bigrig]

Rear bar is something I'm willing to have a lash at, but not the front ... attached is the front bar I'm thinking of - will have a slightly taller centre hoop and hoops over the headlights to attach the UHF aerial and shredders [rod holders].

Talking to the bloke to go throught the details at 5pm this arvo ... should work well with the whole 'pipework' concept I am looking for ...

gq_03.jpg

[Silver]

Rear bar is something I'm willing to have a lash at, but not the front ... attached is the front bar I'm thinking of - will have a slightly taller centre hoop and hoops over the headlights to attach the UHF aerial and shredders [rod holders].

Talking to the bloke to go throught the details at 5pm this arvo ... should work well with the whole 'pipework' concept I am looking for ...

gq_03.jpg

Intended as a mounting point for various things, rather than keeping grasshoppers out of the radiator? Looks tidy.

[Clunk]

looks very nice indeed mate, reckon it would look better with a larger diameter bar though

[GUtsy ute]

Sorry I didn't get back to you last night Scotty,
Can't seem to send the pic.
I'll ring you tomorrow. If you're up my way, I'm home tomorrow also, if you want to drop in and I'll show what I
had in mind.

Cheers Gavin

[Bigrig]

Sorry I didn't get back to you last night Scotty,
Can't seem to send the pic.
I'll ring you tomorrow. If you're up my way, I'm home tomorrow also, if you want to drop in and I'll show what I
had in mind.

Cheers Gavin

No worries mate. See how I go for time - putting those bars on this morning now the welds are all ground back and they're painted up, and then have to go pick up the drawer system and put it together.

Changed my mind about the front as you probably saw in post below ... going tube concept ...

Completed rear bars - came up good.

ImageUploadedByTapatalk1306357705.365674.jpg

ImageUploadedByTapatalk1306357735.747704.jpg

[Dhuck]

Damn they look good. That DhuckRig Industries did a good job for ya

[Silver]

very tidy. You are going to be busy putting all that together if it is to be ready for LCMP BigRig

[Bigrig]

very tidy. You are going to be busy putting all that together if it is to be ready for LCMP BigRig

All done - just finished packing. You'll see them in the flesh when you get up there ..

DhuckRig enterprises done good!! lol