GU Door Striker Bolts won't budge

[Njrqs]

Thanks all. Yes after trying a regular Phillips head I dragged out the impact driver (the one you bAsh with a hammer)

I’ve stripped the screw heads. I’ll try a bigger hammer but failing that yes I’ll try welding (but don’t want to bugger my paint)

Otherwise grind them off

Yeah “Easy out” LOL I love that name.

[mudski]

A quick zap with a mig shouldn’t put enough heat into the area to wreck the paint.


Sent from my iPhone using Tapatalk

[BillsGU]

A lot of impact drivers come with a No 2 phillips head bit. What you want for that sized screw is a No 3 bit. Unless it is really flogged out the correct bit should still do the job.

Also, did you make sure the impact driver was locked in the correct direction before hitting it with a hammer? You have to pre set them to go either left or right. Also, you should turn the impact driver slightly in the direction you want the screw to turn to give the driver a bit of preload, and then give it a hit with the hammer. I have used mine dozens (if not hundreds) of times - especially when working on motorbikes - and have never had an issue, even with the most stubborn of screws.

[Njrqs]

Thanks Bill and co. Yes I’m sure it’s going the right way. I’ll have to try the mig option as I’ve buggered the screws now.

Good source for new ones?

[rusty_nail]

Hi all.

Bought new drivers door striker as my rubber covering was worn. Cannot get the bolts out. Have soaked them in Rostoff and used impact driver. No luck.

Any ideas? Top bolt has some yellow paint mark on it. Unsure what that is for.

Cheers

out of curiosity can you upload a pic mate?

[MB]

Possible idea here Njrqs Mate?
Try a solid 10mm -ish punch/real smack ( no greater than the size of your pan bolt head) to shake up the OEM paint and years of great service.
Truly just did this the day before last on an old Louisville twuck swapping sides as they no longer make em :-(


Sent from my iPhone using Tapatalk

[garett]

been using a punch to turn bolts/screws sorta like the old cold chisel trick for nuts. i also have a removal kit that u drill a hole hammer a bar in then slide a nut onto the bar, works unlike easyouts.. but i must say the punch trick works better than the extractors i've tried.

[Njrqs]

Thanks again all. It's in the "TFH basket" for now !!

Oh and here is the photo someone asked for.

[PeeBee]

I would drill the screw out, diameter no bigger than the root diameter of the screw, maybe a hair less, then it will simply fall out - guaranteed.

[Fireblade]

use an angle grinder or dremmel and cut a flat slot in it. then use a flat screw driver to try turn it out
the heat from the grinder might help to.

not saying it will work but that method has worked for me in the past in some situations