What did you do to your Patrol today!

[mudski]

Swapped a flasher relay to LED compatible one. Indicators clicking as they should now.

Also attempted to fit radius arm spacers , to push the front axle forward to clear the mud flaps.
Chassis on stands , jack under diff...
And then realised I don't have a deep enough 24mm ... ugh.
So I called it a day. Lol

Sent from my SM-N920I using Tapatalk

I have a 24mm Ring/ Open ender I used for mine here your welcome too mate.

[Hodge]

I have a 24mm Ring/ Open ender I used for mine here your welcome too mate.

I do own one of them. But they're useless as the opening from under or the side don't allow much room to manourve the spanner.
Needs a deep socket with an extension and ratchet from the rear opening.

Sent from my SM-N920I using Tapatalk

[Bidja]

I do own one of them. But they're useless as the opening from under or the side don't allow much room to manourve the spanner.
Needs a deep socket with an extension and ratchet from the rear opening.

Sent from my SM-N920I using Tapatalk

Throw up a couple of pics mate. Be good

[NZ42]

Fitted water meth kit by Snow proformance. fingers crossed

[PeeBee]

Fitted water meth kit by Snow proformance. fingers crossed

What motor and kit are you matching?

[mudski]

Wasn’t today but Sunday. I had to replace the reverse camera on the small barn door. So while I was at it I made up a new plastic seal thingo for the door, sikaflexed up any holes in the door to try and stop the exhaust leaking into the cab. Didn’t work though. I also removed the inner door handle.

Now to find where this exhaust leak is... I have to drive with the air on recirculate all the time otherwise when I stop moving I get a nose full of exhaust fumes.


Sent from my crapPhone using Tapatalk

[PeeBee]

Does the GU have vents in the rear quarter panel/outer skin like the GQ? This is where I find a bit of dust entering my vehicle. Might be a spot where exhaust is recirculating?

[mudski]

Does the GU have vents in the rear quarter panel/outer skin like the GQ? This is where I find a bit of dust entering my vehicle. Might be a spot where exhaust is recirculating?

Yeah they do. I'll tape them up and see if it makes a difference. I'm also going to change the direction of the exhaust tip so it comes out just behind the mudflap.

[PeeBee]

I also notice your door seal is hanging down, maybe another entry point?

[mudski]

I also notice your door seal is hanging down, maybe another entry point?

Thats how its shaped to the door. Just looks like its hanging off. All new seals on every door maybe 2 years ago.