drove it to work.
drove it to work.
engine oil and filters.
air filter
sway bar d bushes
inner axle seal
repack bearings
seal rear pinon
rotate tyres
front pads
if its worth doin its worth over doin
Worked out my trailer plug is playing up , blinkers are barely visible ,brakes are non existent but tail lights are good .
Cleaned it out and gave it a quick wash
Sent from my iPhone using Tapatalk
2008 GU6 3.0 CRD AUTO | Safari Snorkel | 2" Ironman lift kit | Runva 11XP Winch | 33" MTZ's | Full Length Roof Rack | GME TX3200 | 30" LED Light Bar |
Scratched the body work on a track that mustn't have been used in 5 years. It's at the point where polishing achieves very little.
As I lay there looking up, taking in the spectacular view that was the night sky and the multitude of stars I asked myself, where did my tent go?
GQtdauto (8th April 2018)
GQtdauto (8th April 2018)
Thought about it as I pondered over the wounds I encountered from putting the flanged inlet elbow back on the CRD turbo with alternator still in place-try it out!!!
Also installed second EGR plate (inlet manifold) both ends blocked now, and put all back together after discovering that my turbo comp wheel thrust bearing was shot. New turbo and 3"ducting on the mod list (what an excuse for an upgrade)...
2008 GU WAG ST Manual CRD - To do the job
MB (9th April 2018)