What has made you Angry Today???????

[BigRAWesty]

never seize graphite would be my choice if they recommend it

Yep.. or coppercoat..

[the evil twin]

snip...
I'll get the bloke to grease the shaft before it goes in

Not much anyone other than Clunk can add to that...

[BigRAWesty]

Not much anyone other than Clunk can add to that...

One greasy shaft is enough I think......

[TPC]

I'll get the bloke to grease the shaft before it goes in

Not much anyone other than Clunk can add to that...

...................

[BigRAWesty]

...................

I was a bit worried for a minute....
But good episode.. lol

[mudski]

Tried jacking bolts in the nose cone, had em near snapping point..
Then swapped to a jacking bolt setup and was bending 5mm plate..

Hmm. Theres a cover plate that needs to come off first. Using 3 bolts, i think they are 6mm thread, evenly screw them in and the cover plate comes off. Then you need to remove the centre nut, and theres a circlip in there too from memory. A gear puller is needed now to remove the pulley.
Once the pulley is off you need to press the bearing out. The centre part of the pulley flexes so make sure it stays in the same position when removing and installing the new bearing because if you dont the pulley wont be centred on the pump when you put it back together and the pulley will be out of alignment with the rest of the pulleys.

Sent from my SM-P600 using Tapatalk

[BigRAWesty]

Close..
But yes that plate has the 3 jacking bolts in it. 3 @ 5mm
Removed the middle bolt first, it holds the nose cone/ cover plate in.
Had them done up to nearly snapping and no go..
So made up the jacking plate to try and budge it but ended up bending the plate. . (3rd bolt is behind middle jacking bolt..)
She is seized on good..
Once plate is off then cir clip and puller to get pullie off...

But never got that far..

[taslucas]

1 too many 1900?

>>>tappin from tassie

[Plasnart]

1 too many 1900?

>>>tappin from tassie

Haha nah mate keep that stuff off the work phone! Seriously no idea where its gone, but if you give me your no I get unlimited standard calls so might save me the 1900 costs?

[mudski]

Close..
But yes that plate has the 3 jacking bolts in it. 3 @ 5mm
Removed the middle bolt first, it holds the nose cone/ cover plate in.
Had them done up to nearly snapping and no go..
So made up the jacking plate to try and budge it but ended up bending the plate. . (3rd bolt is behind middle jacking bolt..)
She is seized on good..
Once plate is off then cir clip and puller to get pullie off...

But never got that far..

Yeah its been a while since I did mine but had done it three times. Lol.