Needle valve setting
I have had the NADS setup for a while, but I suspect the spool up rate is too fierce. It has been set and forget since install.
So a question: Do I close or open the needle valve to slow down spool up rate?
I know, I know I could just change it and see what happens, but I really want to make small changes, as the truck goes quite well like it is--just gets to 15 or 16 psi really quickly.
Dawes set at 17 psi.
Thanks
GU IV 2006; 3.0 DDi ST-S; Nissan Snorkel, Bull Bar and Tow Bar; Warn 8,000# Winch with Dyneema rope; Auber EGT, Boost and dual Battery gauges; Provent 200; Dual Batteries; Three Dogs recovery points; Rear Springs +20% load; Outback drawers and Cargo Barrier; UHF; [GPS, Radio, CD, Bluetooth, SD, USB] floor extension; Alloy roof rack
"Smart people know what they don't know"
To slow down the spool up you need to open the needle valve up.
BigRAWesty (15th July 2016), Dr Gary (16th July 2016)
Posting Permissions
Reply With Quote