Jay see 1997 GU build up

[jay see]

Cheers Hodge.
Any info is good info..
Think I'm just over thinking things.

Sent from my XT1068 using Tapatalk

[threedogs]

Cant you space the front diff 12mm forward to prevent this happening.
Heard or read something about it

[Bacho86]

Think this would definitely be overdoing things IMO - fit the new tyres on first and if required trim / remove front mud flaps


Sent from my iPhone using Tapatalk

[jay see]

I was at my folks place last night and was flicking through the local paper and saw ad for a tyre place in South Morang rang them up this morning and was quoted 1900, asked if they could do 1800 and if they had them in stock. Yes and yes.





Did a few tight u turns and no robbing at all😂. This is will the wheel turned. It may be due to the 2 degree offset brush.



One concern I had was in the wet, well today was a good day to test them, drove a bit harder into the corners around home and I'm impressed.

Drivers side.


Passenger side.


Slight difference that adjustable panhards will fix, but it's not much do that can wait.

Tried to get a wheel alignment at pro axle for today, but they're full, will try for another day asap.

Cheers everyone for the input.

Sent from my XT1068 using Tapatalk

[Bacho86]

Good outcome mate, nice work!

[gubigfish]

$1800 just for tyres or was that Rims as well?

[jay see]

1800 for 4 ROH 16X8 -13 with 305/70/16 BFG KM2s.

Sent from my XT1068 using Tapatalk

[jay see]

And it even throw my speedo back to only 2ks out.

Sent from my XT1068 using Tapatalk

[threedogs]

Betcha you dying to test these babies out, I take it they are nice and quiet ATM.
what pressures are you running or going to run

[Hodge]

Toolangi and dissa are nice and greasy right now if you're keen to take the shine of the new rubber.

Sent from my SM-G920I using Tapatalk