What did you buy today

[macca]

Here you are Cuppa, a quick search and found this for you

http://www.ebay.com.au/itm/like/1518...pid=107&chn=ps

[Touses]

Does it click on/off the hose like other air fittings, it looks like a permanent fitting in the pic.

Heya Cuppa! Like Macca shows in the link,a good positive fitting. Yes it is a permanent fixture.
Cheers Rob.

[Bacho86]

Use that type on my car, work well. Doesn't fall off and you don't have to hold it on either

Good to hear. The thumper has a screw on one, whilst it doesn't fall off either can just be a PITA to get on and off all the time!

[Winnie]

Deleted post

[threedogs]

http://www.ebay.com.au/itm/351454052...%3AMEBIDX%3AIT
This arrived and with some 30 mm heat shrink on the rear should look ok,
this is to be mounted in the corner of the A pillar for dash mounted
gear, again will be held in sitcu with velcro
This heat shrink shrinks very small for its size

http://www.ebay.com.au/itm/121149442...%3AMEBIDX%3AIT

[BigRAWesty]

Good to hear. The thumper has a screw on one, whilst it doesn't fall off either can just be a PITA to get on and off all the time!

It is a pita Ay. .
I'm looking for a fitting that seals like a regular fitting when off the tyre so the compressor shuts off..

[threedogs]

@ Kallen so the compressor set up worked out good.
does it cut out at all pumping up tyres, as in wire
size is adequate?

@ Cuppa one from the old dart may be the one your after

http://www.ebay.com.au/itm/NEW-GENUI...e_FAyz4H544pqA

http://www.ebay.com.au/itm/Jamec-Pem...kAAOxycmBS4JXK

[Bacho86]

It is a pita Ay. .
I'm looking for a fitting that seals like a regular fitting when off the tyre so the compressor shuts off..

Let me know if you have any luck, I would be interested! How'd you go installing yours in the hideen rear arch wheel compartment?

[macca]

It is a pita Ay. .
I'm looking for a fitting that seals like a regular fitting when off the tyre so the compressor shuts off..

The chuck I posted for Cuppa does that, so no air is lost when moving from wheel to wheel etc

[BigRAWesty]

@ Kallen so the compressor set up worked out good.
does it cut out at all pumping up tyres, as in wire
size is adequate?

@ Cuppa one from the old dart may be the one your after

http://www.ebay.com.au/itm/NEW-GENUI...e_FAyz4H544pqA

http://www.ebay.com.au/itm/Jamec-Pem...kAAOxycmBS4JXK

Initial trials have been good although have only really dropped to 20 psi and temps have been quite mild this summer..
But yea wire size is fine..
Just throwing together the last few bits.. hopefully I'll be putting together a pannel this weekend to run all the goodies..

Let me know if you have any luck, I would be interested! How'd you go installing yours in the hideen rear arch wheel compartment?

It's going good.. going to need some sound deadening I think.. it drums like crazy threw the car..
Unfortunately I gave all my leftover deadener away lol..