Hi all just sharing how I did my headlight projector install
Started with this kit from fleabay
http://www.ebay.com.au/itm/301792681...%3AMEBIDX%3AIT
Remember to order with RHD Cut out option also choose your angel eyes colour and the hid temperature
Also got some demon eyes from the same seller for some extra bling
http://www.ebay.com.au/itm/Pair-Devi...-/301829657195
Here is rhe kit all unpacked
image.jpeg
And the demon eyes
image.jpeg
I used a heatgun to soften up the sealant then pried off the glass just take your time and keep applying heat as needed
image.jpeg
Also used one of my trim removal tools to remove the glass found that starting from the bottom was best
image.jpeg
Remove the outer shield two Philips screws
image.jpeg
Now remove the reflector by undoing the headlight adjuster screws on the back of the light then a bit of force to get it off the clip
image.jpeg
image.jpeg
image.jpeg
Now remove the globe holder spring and shield held in by a small Philips screw and discard
image.jpegimage.jpeg
Time to paint the reflector and outer shield if you choose to this is an option I wanted mine black so in to the paint booth it went first for a coat of adhesive promoter
image.jpeg
So while paint is drying remove the globe holder on the projector I also installed the demon eyes at the same time
image.jpegimage.jpeg
Now fit the H4 size silicone washer from the kit ready for installation I chose to seal of the back of the projector with aluminium tape as I found the demon eyes was reflecting out the back
image.jpegimage.jpegimage.jpeg
Couple of coats of flat black and ready to come out of the paint booth lol
image.jpeg
Now with clean hands start assembling careful not to scratch the new paint job
Fit projector into reflector housing making sure the wires go in the bottom slot select the H4 washer from the kit and tighten up the nut
image.jpegimage.jpeg
Fit the globe holder and the hid globe and then back into the light housing start the two adjuster screws first then press on to the stud
image.jpeg[ATTACH=CONFIG]66091[/ATTACH
Fit outer shield and refit the glass remember to blow out light with air and clean the inside of the glass
image.jpegimage.jpeg
All done now repeat for the other side and done job took approx 4 hours from go to whoa there is a complete wiring harness that comes in the kit witch is nearly all plug and play wee bit of soldering for the Angel and demon eyes easy done here is the end result
image.jpegimage.jpegimage.jpegimage.jpeg
Send from my iPad cos this site rocks now on the tablet now that Andy fixed it