Forgot to mention, used the freeze and release can as well.
Forgot to mention, used the freeze and release can as well.
MudRunnerTD (5th March 2016)
Good job bloke
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.Originally Posted by Rogue Dung Beetle
WARNING: Towballs used for recoveries can, and do kill people and damage property.
AB (5th March 2016)
I had to drag poor Rossco over with his welder to weld a nut on.
There was no way it was coming off without it.
Even then the welds were cracking and Rossco was watching the engine move as I was undoing the stud.
Crazy seized!!!
Yeah but you won
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
AB (5th March 2016)
Yeah they were pretty tight. Think we were lucky must of been getting pretty close to that front stud snapping, pretty crazy how much force was going through that little thing, it was twisting the whole motor!!
Just waiting on one more part and I can bolt everything up!
Made up a new support for the fatz airbox to raise it up another 10mm for better clearance of the 4" pipe to turbo and also to allow the aux battery tray to fit because the oem bottom support angle bracket is in the way of the aux tray.
Been a challenging task but it's all ready to bolt up!
Pirtek are awesome! Managed to keep most the original oil water lines, just made up new fittings to suit Borgwarner.
Rossco (6th March 2016)
This is coming along awesome Andy, can't wait for you to take me for a spin to see the difference.
(I still have not taken the airbox out of my car since I picked it up)
AB (6th March 2016)
It does fit good mate but needs slight mod for aux tray and you would need to take a fair chunk of strength away from the alternator bracket so I decided on raising it a whisker.
Rosscos got your flange too mate, special delivery!
Winnie (6th March 2016)
Raising it sounds good. Please take lots of photos when it goes back in. Lol.
I'll catch up with Rossco, cheers for that.
Finally got time to jump back on the gq.
Turbo finally bolted up!
It's a tight fit, slight panel beating to fit the wastegate in.
Just need some more 4" clamps, m8 studs, T piece and hose for the recirculation valve, oil drain fitting and I think I'm ready to connect everything up...Yay!
Clunk (27th March 2016), growler2058 (27th March 2016), MudRunnerTD (27th March 2016), Rossco (27th March 2016), Winnie (27th March 2016)
Posting Permissions
Reply With Quote
