Jay see 1997 GU build up

[jay see]

There will be no problem fitting a tee I done it for my oil pressure gauge as well go check your local hosemasters,pertek or Enzed

Cheers mate.
Will do.

[jay see]

There will be no problem fitting a tee I done it for my oil pressure gauge as well go check your local hosemasters,pertek or Enzed

I've done the drive around and no one stocks a 12x1.25 tee. Hard enough to find anything that's 1.25, so I'm going to tap in a new one here.

1453872593758.jpg

Has anyone got a 1/8 npt tap that I could borrow?

[jay see]

My gauge should arrive next week, after a mix up on there end. Ive run wires though the firewall and up and under the dash.

Where is the best place to get the +&- for the gauge and what about the light.
Had a search for someone else's install but couldn't find one.

[threedogs]

http://www.ebay.com.au/itm/121258984...%3AMEBIDX%3AIT

Is something like this helpfull ???

[jay see]

http://www.ebay.com.au/itm/121258984...%3AMEBIDX%3AIT

Is something like this helpfull ???

Yes, but not for the temp gauge.

Any threads showing how to install.

[gubigfish]

check these out jay see http://www.ebay.com.au/itm/5-X-ADD-A...YAAOSwa39Uyve7 credit to ET, its what I used to get +ve for my EGT gauge, I had an existing -ve wire connected to one of the bolts behind the centre part of the dash. You can also get those adapters from Repco and SCA however you'll pay a fortune for one.

[jay see]

Wanting to lose the plugs for the dash cam and the GPS. Is there any problems to cut the plugs off and wire them into the accessories somewhere. Don't think it would be a issue, but want to make sure.

[lucus30]

Wanting to lose the plugs for the dash cam and the GPS. Is there any problems to cut the plugs off and wire them into the accessories somewhere. Don't think it would be a issue, but want to make sure.

If they are just 12v power no problem at all.

[jay see]

If they are just 12v power no problem at all.

Thanks mate. I thought it would be fine.

Now to do something about it.

[jay see]

If they are just 12v power no problem at all.

Another stupid question.

The fuse in the plug is 1amp. The smallest under the dash is 5 amp, do I just disregard it?

Like I've said in the past and continue to prove in the future, I not electronically minded.