Anybody know the torque settings on the TB48E valve cover bolts, sometimes referred to as the rocker cover. Have checked the Workshop manual, but TB48 in my collection do not have the torque settings, can see for the TD42 it is very low 2-3 Nm.
Sent from my LG-H818 using Tapatalk
Yep me and my brother have just done valve clearances and the rocker cover bolts need bugger all tension..
I snapped one and I had stuff all force on it..
So when you feel it getting tight stop. Lol
And no leaks in mine so must be right..
Cheers
Kallen Westbrook
Yep 2-3 Nm for all 6mm bolts
98 GU ST wagon 6.5TD chev 5 speed manual dual batteries storage drawers big red air compressor 9L tank millweld front and rear bars millweld 4" snorkel 4" air box 3" tough dog suspension lift drop box and hybrid radius arms 12000Lb winch ARB front air locker Alpine MP3 player amp and a good set of speakers GME 2 way The list goes on
Thanks folks. Hopefully the rocker gasket is where my oil is leaking from and not my head gasket.
Sent from my SM-T805 using Tapatalk
Usually you'll see oil around the bolt headsOriginally Posted by vanhack
vanhack (25th January 2016)
Anyone know which of the O2 sensors plugs are bank 1 and 2, connectors are identical, and I did mark them. I have O2 sensors before cats only.
Sent from my SM-T805 using Tapatalk
I ended up replaceing the rocker bolts with normal bolts as the head of my bolts werestripped.
it was around m6 * 25 mm
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
BigRAWesty (25th January 2016)
Posting Permissions
Reply With Quote