There's a lot of info I no longer get (nor need) on mine such as timing & MAF, O2, etc. anything that related to EFI but I'm happy to get real engine temps & volts without having to add gauges & sensors. I also used it to set my TPS and it will show if my TPS has an issue.Originally Posted by mudski
Other big advantage for me is that I can still do full auto trans diagnostics via Ecutalk.
John
2001 GUII TI 4500 - Now converted to TD42T auto with Nomad valve body
mudski (18th December 2015)
Ok next dumb question where is the port to plug in the cable
2004 4.2TDi GU ST Ute, 3" Exhaust, UHF, Lightforce Spotties, BFG All Terrains, Steel Winchbar, Winch, Dual Batts, CC Ultimate IC, 4" Snorkel, XLR8 Steps and Scrub bar
Should be under the steering coloumn
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
gubigfish (18th December 2015)
Just at the edge of the plastic trim that is under the steering wheel. Its a white plug.
Bugger. now I want an ECU talk again to read my water temps...
Did you read my post above does yours have provision for that ?
Workmates 2002 4.2 doesn't. It's not a tdi.
Just in case you buy it lol
Tapatalked from S6
2005 TD42TI
Did you keep your ZD30 ECU in place during the conversion?
John
2001 GUII TI 4500 - Now converted to TD42T auto with Nomad valve body
@ Eric does your centre,, console right of the gear stick have any switches there?
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Yeah mate. That antenna switch is doing nothing. It'll be replace with front locker switch early next month...
Tapatalked from S6
Last edited by Hodge; 18th December 2015 at 04:58 PM.
2005 TD42TI
You just mounted the switches ,,I brought the inserts that the switches fit in.
Good to see there is enough depth for switches, Thanks for that>
Read Stropp's thread on the Ecu-Talk when you get time.
Putting 3 there too, winch isolation switch, front locker and compressor
http://www.ebay.com.au/itm/ARB-Carli...jXGB9Y2A_83Wrw
I used these Baintech Volt gauges to monitor my start and Aux battery,
the other is on the other side of the head unit, IMO I think its a waste putting a
volt gauge in the pillar pod
AND If you dont smoke or use the ash tray you can make
a new lid and fit some more gauges there
Last edited by threedogs; 18th December 2015 at 05:27 PM.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Hodge (18th December 2015)
Posting Permissions
Reply With Quote
