Well that worked out alright westy, old man has a couple GU and he's going to buy 2 locking sliders off me. Get a set of drawers made for himself. So now I'll order 2 none locking ones. Covered me there, thinking it would be a bugger with two locking on each draw
BigRAWesty (24th October 2015)
Well progress so far, pulled carpet out. Painted the floor with white kill rust, and put silicon in all the unwanted holes. Punch 6 holes in carpet for slates and brought longer bolts to go through slates into existing bolt holes.
Sent from my iPhone using Tapatalk
BigRAWesty (24th October 2015)
Yea I built my self and father inlaw a slide for our cf50's and hind site should have only bought 2 locking instead of 4..Originally Posted by Phill265
It's just a pita with to..
Cheers
Kallen Westbrook
Yeah just a bugger lifting two up, and trying to get the drawer out.
Next up cut 6 slates of 12mm ply at 30mm wide. Glued 2 together to make 3. Trimmed the one just behind the seat to make lvl, then added a small block in the centre of it for support.
Sent from my iPhone using Tapatalk
Cut floor to size, then drilled holes round bolts for easy access
Sent from my iPhone using Tapatalk
With the bench saw cut a 6mm x 13mm recessed edge on top and bottom. Made a couple square edges, with holes to clap square with, glued and screwed together
Sent from my iPhone using Tapatalk
BigRAWesty (24th October 2015)
screw runners in went with one locking one, and one non locking slide per draw as suggested.
Sent from my iPhone using Tapatalk
boxed the drawers and screwed them to runners
Sent from my iPhone using Tapatalk
DX grunt (20th October 2016)
place drawers on base screwed down, made wings wrapped in marine carpet.
Sent from my iPhone using Tapatalk
Posting Permissions
Reply With Quote
