Step 3
clean up the cut on the bush housing and give it a bit of a "vee" to make it easier to weld, center it on one of the base plates making sure the holes in the bush line up straight with the bolt holes in the plate
IMG_0509.JPG IMG_0508.JPG
tac it on one side and check that it's level, tac the other side and check, check and triple check everything is where you want it. Grab the welding gun again and zap it on
IMG_0511.JPG IMG_0512.JPG IMG_0514.JPG
give i a hit with the wire brush and blast with some black paint, i prefer to paint it while it's hot as it seems to bake on there pretty good, hang it up to dry and hit it with a few more coats as needed
IMG_0515.JPG IMG_0516.JPG IMG_0517.JPG
Reply With Quote