GU converting auto hubs to manual

**Winnie** · 6th August 2015, 07:23 AM

Originally Posted by Rocket55

You don't need to jack it up or pull the tyre off do you?? Just undo the 6 or 8 cap bolts and pull the hub off??

That's correct

**Rocket55** · 6th August 2015, 08:19 AM

Well that really makes it a 10 minute job

**mudski** · 7th August 2015, 03:36 PM

Yep. Just buy a cheap socket to fit the hex that locks the hub and weld a 3inch or so piece of flat bar to it on its side and you have a small tool to lock the hubs which you can keep in the door pocket.

**boots** · 7th August 2015, 05:03 PM

Or just go to bunnings and get a plumbers pipe socket that fits. already has the bar with it.

**mudski** · 7th August 2015, 07:47 PM

Originally Posted by boots

Or just go to bunnings and get a plumbers pipe socket that fits. already has the bar with it.

Or you could do that!

Sent from my SM-P600 using Tapatalk

**SpecialDave** · 11th August 2015, 02:10 AM

Or cut the end off an old tyre wrench leaving a bit of bar... Bang done.. No welder or purchase required.

Sent from my iPhone using Tapatalk

User Tag List

Thread: GU converting auto hubs to manual

Thread Tools

Display

The Following User Says Thank You to Winnie For This Useful Post:

The Following User Says Thank You to boots For This Useful Post:

The Following User Says Thank You to mudski For This Useful Post:

Posting Permissions