Zd30 power loss.. cnt even pull skin off the custard..

[mullet_hunter]

Champion mate... thnks

Sent from my SM-N915G using Tapatalk

[Hodge]

I am posting the ecu talk tomorrow mate. Ill look for the maf and send them together.

Sent from my SM-P600 using Tapatalk

Is the CRD and Di MAF the same? I think I still have my old one (working) when I was eliminating faults a while ago, and bought a new MAF from you. If you're struggling and IF I find my old one, I'm more than happy to hand it over for him to try.

[Hodge]

Sorry, that was providing they're the same...

[mullet_hunter]

Algood hodge.. think there difrent.. ive got the earlier round one and url have the latr square one.. thanks tho mate...

Sent from my SM-N915G using Tapatalk

[threedogs]

Are all your fuel lines clear with no partial block
can you disconnect at the tank end and the IP end
and blow a small amout of air through the fuel lines.
You're not sucking air anywhere are you.
Did you disconnect the battery when you installed the TPS.
as the ECU may have memory of the old one. just throwing it
out there for you.

[mullet_hunter]

Ye mate tried all that and more.. lol.. im hoping if i just replace the maf it will come right..

Sent from my SM-N915G using Tapatalk

[threedogs]

Fingers crossed for you mate, no one close by with an ECU-talk.
Take it down to SCA for a scan Thats all Ive got ATM

[mullet_hunter]

I bort the ecu talk off mudski so should arive some time nxt week... engine light hasnt come on and hasnt thrown any fault codes.. will be able to hopefull diagnose easier wiv ecu talk... howd u go with ur intake setup?

Sent from my SM-N915G using Tapatalk

[threedogs]

Too sore ATM to fit it, I'll have to wait and see how I feel after my next Op[18]
Your Maf I'm going to give to a 4x4 shop and get them to skim 1.5mm out of it.
12mm braided hose gives the engine bay a nice touch with AN10 hose ends lol

[mullet_hunter]

Sexy.. haha

Sent from my SM-N915G using Tapatalk