1st LED -
Charge LED should be green, indicating that the system is charging normally.
The Charge LED will flash green when an overcharge condition or an open battery circuit exists.
2nd LED
The Battery LED is green when the battery voltage is in normal condition above 12.0 volts.
It will blink green slowly when the battery finishes it’s charge which I think is 13.2 float.
Yellow means the battery is below 12.0 volts.
Red when battery is at or below low voltage cutoff which is 11.1 volts and the Load output will switch off.
3rd LED
The load LED is steady red when a load output is operating normally.
If the load current is higher than the rated current the controller will shut down the output and the Load
LED will blink red slowly to indicate that an overload condition occurred.
The Load LED will blink red rapidly if a load short circuit occurs.
Reply With Quote