What has made you Angry Today???????

[BigRAWesty]

Angry is too strong, these bleeding Patrols have their own threads, the universal joint grease nipples are neither 1/4" or 6mm FFS. Today found the wheel studs are not standard 12 mm, the lug nut is loose on standard studs, Nissan must have their own threads. Fair bloody go. Off to the stealers for the correct units. Lucky for me it's not a breakdown situation.

Metric fine mate are most the bolts etc.
I would have though wheel nuts would be imperial though.

[MudRunnerTD]

Angry is too strong, these bleeding Patrols have their own threads, the universal joint grease nipples are neither 1/4" or 6mm FFS. Today found the wheel studs are not standard 12 mm, the lug nut is loose on standard studs, Nissan must have their own threads. Fair bloody go. Off to the stealers for the correct units. Lucky for me it's not a breakdown situation.

Sure they are 1.25 pitch I think. Might have one here with it stamped in, I'll have a look

[macca]

Sure they are 1.25 pitch I think. Might have one here with it stamped in, I'll have a look

Yes they are. The diameter is odd on the car they fit okay but the 12 mm I looked at today did not screw on properly at all. When fully on the lug nut "wobbled" enough to say they weren't a match. No other thread would fit the nut on at all.

[pearcey]

You have to buy correct wheel nut as the pitch is not standard metric, most auto stores have a selection of the correct ones .

[macca]

You have to buy correct wheel nut as the pitch is not standard metric, most auto stores have a selection of the correct ones .

Pearcey, I'm after the 6 studs to put in the swing away for the spare. If I can get Nissan ones they can be spares for the Ute. Will call our Nissan spares and get the right ones.

[pearcey]

Macca front and rear studs are different in the length of the nerl IE the bit that goes through the hub.
If you get 3 of each you have spares for the front and rear , even if you snap 6 off on a hub 3 will get you out of trouble.

[macca]

Macca front and rear studs are different in the length of the nerl IE the bit that goes through the hub.
If you get 3 of each you have spares for the front and rear , even if you snap 6 off on a hub 3 will get you out of trouble.

Good tip ta

[MEGOMONSTER]

George blaming Xmas for not getting the job done yet.
BWAHAHAHAHAHAHAHAHAHAHA

[oncedisturbed]

Having to fill out w/comp insurance forms for info they already know.

Apparently everyone can live on $13.41 gross p/w as thats what the leather gear I have made has earnt since march this year.....bunch of muppets argh!!!

[Clunk]

Having to fill out w/comp insurance forms for info they already know.

Apparently everyone can live on $13.41 gross p/w as thats what the leather gear I have made has earnt since march this year.....bunch of muppets argh!!!

Yep they're bloody clever alright