Hi Everyone.. Well I received my TITAN DRAWERS.. After a slightly painful TRANSPORT / FREIGHT issue which I wont go into except to say that it had nothing to do with 4WD Supacentre. All boxes arrived at my residence..
2 Boxes to do with the Drawers, and one other that I purchased at the same time.
1 box contains the SIDE POD/WING pieces and the mounting bolts that are specific to the vehicle. This was a small box of about 2kg..
The other box is a big one.. It contains everything else. The full DRAWERS, FRAME and Fridge Slide.. all 90% assembled.. It weighs 80+kg..
The quality of the product is absolutely awesome. I am completely wrapped. No complaints at all.. Although I may trim a little bit off of one of the side wings to make it fit easier. It is very VERY tight at the moment. Maybe settling will help but we will see..
Were there any problems in the installation.. Nope.. was all straight forward. Just a bit fiddly getting such a large component to line up so that it is central and lines up with the mounting holes.. Instructions are pretty limited and straight forward though.. Anyone with a little sense and knowledge will be able to fit them in about 1 1/2 hours but it is a 2 person job.. And a good Re-chargable Drill/ Driver will make fitting all the HEX Screws so much easier..
I am going to let it settle for a week or so and then check that all bolts and screws are still tight..
I have a couple of pictures that I will post shortly..
Overall I am very happy..
Cheers.
Reply With Quote