New km2
High mount rebuild install and fairlead, rope and controller
Rear quarter cut and front guard chop
Front mud flaps
Rear bar
Upgrade turbo and pump, 3" elbow to inlet manifold
New airbox
Indicators on new bar
Mesh on roof rack
New flares
Put a half decent stereo and speaker system in.
Run mandrel bends on aux tank main
Leave the stereo!!! You know it!!
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.Originally Posted by Rogue Dung Beetle
WARNING: Towballs used for recoveries can, and do kill people and damage property.
It's at the bottom of the priority that's for sure.
MudRunnerTD (12th October 2014)
Pretty good service from the 4wd shed.
They had a spare main gear cog in their factory for the highmount, gave it to me pretty cheap and sending it today.
They cost an arm and a leg brand new!!!
MudRunnerTD (13th October 2014)
Removed the vertical roller bar off the bull bar.
Couple of miss nicks but overall I'm happy with it!
MudRunnerTD (8th November 2014), Stropp (18th October 2014)
you going to get that bent rod changed out then it will look real good
2003 gu3 td42tdi sold 😞 bloody gvm towing crap. Bt50 3500kg gvm.
Going to have to, tried pulling it out but no joy...you going to get that bent rod changed out then it will look real good
Looks good bent - character! ! Just smash the rest a little and it will look tuff as!!
Alitis007 (19th October 2014), Drewboyaus (18th October 2014)
Well you wouldn't believe it, it actually works!
Nice hot day (for us Mexicans) in Melbourne today so tested the gq out for the hottest day yet since front mount ic.
Water temps got to half way on some of our long ass hill climbs in the area.
Put 4 washers under each bonnet hinges, same time of the day and tried again.
Not an amazing result but temps sat a couple of mm below pre bonnet raise.
Makes sense, 2m wide x 8mm reverse scoop to release heat
growler2058 (8th November 2014), Stropp (8th November 2014)
Or draw cool air in......
growler2058 (8th November 2014)
Posting Permissions
Reply With Quote